21
5.Screw in the housing base with the enclosed screws.
6.Pull the red security pin on the smoke alarm from position OFF to position ON and
clamp it into the intended notch on the smoke alarm.
7.Reconnect the device with its housing base, by plugging the holding clips of the
housing base into the appropriate slots on the device and turning it clockwise.
Attention!
The smoke alarm is equipped with a security equipment avoiding the locking of the hou-
sing, if the red safety pin is not in position ON.
Operation
Please check the function of the smoke alarm, by performing the
function test
weekly
and whenever in doubt about it. After 10 operating years the smoke alarm must be
replaced. This is indicated by the smoke alarm by 3 short beeps all 43 seconds.
Function test
Press the test button (TEST/HUSH) on the underside of the appliance until the alarm tone
sounds. This stops after the release of the test button. If there is NO alarm sound, the
appliance CANNOT send an alarm signal, and it must be IMMEDIATELY replaced.
Alarm Muting (HUSH)
If an alarm is released for example by cooking fumes, it can be muted for 9 minutes by
pressing the TEST/HUSH button. After that the smoke alarm will be automatically reset
into the normal operating mode.
The muting an also be switched off by pressing the button TEST/HUSH again.
PAY ATTENTION:
If there is still smoke in the smoke chamber of the smoke alarm, it
will send a new alarm signal.
33509-Manual-RZ.qxp_Layout 1 24.03.16 12:26 Seite 21
