How to use:
Switch on generai power and pick up the dryer body,the dryer
will work when the spring button is held on, move the push
button up and down tor higher or lower heating.
"MAX"
tor hot
heating,"MIN" tor warm heating.
Notes:
1. Ensure the voltage of hair dryer is same with the power
supply.
2.Please tollow the below safety frameworks when you operate
the hair dryer.Don't operate the hair dryer when your hands
are wet.Don't pull out the combined card , Don't let the man
who don't know how to operate the hair dryer operate it alone
except minitored by man.
3.Clean and keep hair dryer
Please pull out the power plug from electrical outlet when
you cleaning the hair dryer. Please pay attention the hair
dryer to avoid absorbing in the i niet of hair dryer. Please
use the cleaning solution of water with soap to clean the
housing of hair dryer,don't use spray liquid or abrasive.
We don't responsible
tor
any danger things if you don't
follow the above instructions.
Parts in the package:
one set hair dryer
one manual
Accessori es:
one pothook two piece of screws two piece of goggles
-
•
•
Wall-Mounted Hair Dryer
Thank you very much far becoming a user of our
products,which will bring conveniece and pleasure
to you in coming days.
This series Wall Mounted Hair Dryer focuses on
safety, convenience and power-saving with modern
streamline shape, shows smart combination ofScientifics
and aesthetics, lt's installation method is amazing
because it can be installed both in drawer and on wall,
lt's a ideai choice far hair-drying in hotel and family.
Features:
1.Characterized with a generai power switch to allow this unit
be power off when is not in using.
2.Two heatings
3.Slightly press on the spring button to turn on and work,
release that switch to turn off.
1.dryer body
2.holder
3.transparent cover
4.indicator
5.power
6.Spcket
7.spring button
8. switch
4
7
Warning:Don't install the hair dryer in barhroom and other
places easy wet.
How to install this unit with plug connected wire:
1.Drill 2 holes of 6mm dia meter
according to the dimension
shown in picture 2 then insert
toggle into that holes and fix
its hanger to top ho le.
2.Align installation cilp on the
back cover to the hanger and
push down, fix front and back
cover on wall with the screw ,
then insert toggle into screw
hole.
Picture 3
3.Connect with generai power and move power switch to " ON"
position.
How to install this unit without plug-connected wire:
1.As per first step of the method
IIF::;:;;�;;7
above.
2.Loosen the screws as per pie
ture 3 to remove front cover and
remove to plug-connected wire
from terminal.
3. Open the wire entry hole; pull
the reserved wire through that hole.
Then align installation clip on the
back cover to the hanger and push down,fix b
wall with the screw ( picture 4).
Picture 4
4.Fix the reserved wire on terminal,please notice its direction of
N,L wire, replace terminal to its ori
5.Fix front cover after checking that there is no mistake.
6.Turn on generai power and move power switch to "ON" position.
