Vitek VT-PTZ12W, User Manual

Page: 40 / 50

VT-PTZ12
38
3.5.3 PRESET FREEZE ( MENU => SETUP => PRESET FREEZE)
This option is used to set the pause previous image until the preset action is complete.
3.5.4 PANNING RANGE ( MENU => SETUP => PANNING RANGE)
When the dome camera is
installed near a wall or on a corner, panning range can be limited by user.
3.5.5 TILT LIMIT (
MENU
=> SETUP => TILT LIMIT)
Turn Tilt Limit OFF to the allow the camera to have full range of tilting ability from 0 ot
180 degree.
Turn Tilt Limit On to limit the tilting range by up to +10 degree on both ends.
During zoom-out operation the tilting range is increased slightly by additional
+10 degree.
3.5.6 CALIBRATION (
MENU
=> SETUP => CALIBRATION)
RESET ORIGIN :
Calibrate the ORIGIN point.
OFFSET ORIGIN : Adjust the small amount of position error from re-installation.
ACTIVE OFFSET : Apply the adjustment above or not
AUTO CALIBRATION : ON – When position error detected, recover automatically.
OFF – Disregard the position error.
PAN RANGE SETUP
RIGHT LIMITE : 000.0
LEFT LIMT : 007.2
ENABLE : ON / OFF
SWAP RIGHT LEFT
SAVE AND EXIT
CALIBRATION
RESET ORIGIN
ORIGIN OFFSET : 000.0 , 000.0
ACTIVE OFFSET : DISABLE/ENABLE
AUTO CALIBRATION : OFF
SAVE AND EXIT