3
- Please follow these steps if the equipment has trouble
- Make sure the equipment is installed according to the installation guide
- Configure RJ45 cable order meets EIA TIA568A or 568B standard
- Every PoE port can provide maximum power of uo to 30W
- Please contact your vendor if trouble still exists
Troubleshooting
Specifications
Instruments to be used wire crimper network tester Wire sequence of RJ45 plug should
conform with EIA TIA568A or 568B
1 Please remove 2cm long the insulating layer and bare 8 pairs UTP cable
2 Separate the 8 pairs UTP cable and straighten them
3 Line up the 8 pieces of cables per EIA TIA 568A or 568B
4 Cut off the cables to leave 1 5cm bare wire
5 Plug 8 cables into RJ45 plug make sure each cable is in each pin
6 Use the wire crimper to crimp it
7 Repeat above 9 steps to make the another end
8 Use network tester to test the cable if t works
Pin Color
White
reen
G
Green
Blue
White Orange
White
lue
B
White Brown
Orange
Brown
1
2
3
4
5
6
7
8
Pin
Color
1
2
3
4
5
6
7
8
White Green
Green
Blue
White Orange
White Blue
White Brown
Orange
Brown
EIA TIA 568A
EIA TIA 568B
1
8
1
8
Wiring
(888) VITEK-70 | WWW.VITEKCCTV.COM
28492 Constellation Road Valencia, CA 91355
Detailed Specifications
Ports
PoE Standard
PoE Pin assignment
LED Indicators
Switching capacity
MAC address table
Traffic control
Thermal methods
Input voltage
Power consumption
Operating temperature
8 - 10/100Base-TX PoE Ports / 2 - 10/100Base-TX ports
IEE802.3af, IEEE802.3at, per port 30W(MAX) / Total 130W
V+ (RJ45 Pin 4, 5), V- (RJ45 Pin 7, 8).
PWR, PoE, Link/Act LED
2.0G
4K
IEEE 802.3x full-duplex flow control
Fanless
100V 240V AC 90/60Hz (for power adapter) / 48VDC (for PoE switch)
130W (125W for PoE)
32º~104ºF (0º~40ºC) / 20~85% RH
8 Port 125 Watt Compact PoE Switch
Preliminary Specifications:
VT-8P125
