Vitek VT-8551, Manual Instruction, Page: 4 / 20

4
ENGLISH
–
Unpack the unit completely and remove any
advertising stickers that can prevent the unit
operation.
–
Check the unit for damages; do not use it in
case of damages.
–
Before switching on, make sure that the oper-
ating voltage of the power adapter corre-
sponds to voltage of your mains.
SWITCHING ON
–
Place the unit on a flat steady and dry surface.
–
Insert the power adapter (7) cord connector
into the connection socket (6).
–
Plug the power adapter (7) into the mains
socket.
–
Touch the power switch (1) « », the ioniza-
tion mode will be switched on and the indica-
tor «Ion» will light up.
–
Touch the power switch (1) « » again, the
ionization and fan mode will be switched on
and the indicator «Fan Ion» will light up.
–
To switch the unit off, touch the power switch
(1) «
» once more, the unit will be switched
off and the indicators will go out.
–
The air purifier can operate for a long time,
but, just as when operating any other electric
appliance, you have to follow the safety regu-
lations: unplug the unit when you don’t need
to use it.
Note:
–
If the electrostatic collector (3) is not installed
or installed improperly, the unit will not switch
on (pic. 1).
–
Soft crackling during the unit operation is
connected with high relative air humidity in
the room, it is normal.
CLEANING THE UNIT
Body
–
Regularly clean the grids (2 and 5), you can
use a vacuum cleaner for cleaning them.
–
Clean the unit body with a slightly damp cloth
and then wipe it dry.
–
Never immerse the unit into water or other
liquids.
–
Do not use abrasives and solvents to clean
the unit body.
Cleaning the electrostatic collector (3)
It is recommended to clean the electrostatic col-
lector (3) plates once a week.
–
Disconnect the power adapter from the
mains.
–
Remove the electrostatic collector (3) by pull-
ing it upwards by the handle (pic. 1). Do not
touch the plates until you have removed the
remaining static charge. To do this, let the
plates touch any grounded object, such as
water pipe or tap.
–
Wipe the plates with a slightly damp cloth to
remove dust particles (pic. 2); dry the electro-
static collector for some time. Before installa-
tion, make sure that the electrostatic collector
plates are completely dry.
–
Install the electrostatic collector (3) back to its
installation place (4).
STORAGE
–
Clean and dry the unit body and the electro-
static collector before taking the unit away for
long storage.
–
Keep the unit in a dry cool place away from
children and disabled persons.
TROUBLESHOOTING
Problem Possible causes Solution
The unit
would not
switch on 1. The power adapter is not connected
to the mains. The power adapter
connector is not connected to the
socket (6).
2. No voltage in the mains.
3. The electrostatic collector is not
installed or installed improperly.
4. Malfunction of the unit
1. Plug the power adapter into the mains.
Insert the power adapter connector into
the connection socket (6).
2. To check, plug another appliance into
the same socket.
3. Check whether the electrostatic
collector is installed properly.
4. Apply to an authorized service center
for repairing the unit.
IM VT-8551.indd 4 21.06.2018 17:23:57