6
ENGLISH
•
Check the unit for damages, do not use it in case of
damages.
•
Before plugging the unit in make sure that the operat-
ing voltage of the unit corresponds to the voltage of
your mains.
•
The unit is intended for operation with AC system and
50 or 60 Hz frequency. The unit does not need any addi-
tional settings for operating with the required nominal
frequency.
HAIR STRAIGHTENING
•
The unit can be used for both long and short hair.
•
Use the unit only on healthy undyed and not permed
hair or use it along with special hair straightening
products.
•
If your hair has been dyed or permed, use the unit rarely.
•
For the best results the hair should be clean and dry.
•
Open the hair straightener pressing the clamp (5).
•
Put the unit on a flat steady and heat-resistant surface.
•
Insert the plug into the socket, switch the unit on by set-
ting the power switch (3) to the position «I», the power
indicator (2) will light up.
Note:
During the first operation some smell from the heat-
ing element is possible, this is normal.
•
Let the unit heat up.
•
Divide combed hair into locks of equal width (about 5 cm).
•
Place the hair lock between the plates (1).
•
Hold the unit by its handle (4) and press the plates (1)
together.
•
Slide the heating plates (1) with little force to the hair tips.
IMPORTANT
: do not keep the plates on the same area of
the hair lock for more than 2 seconds.
•
After that start straightening the next hair lock.
•
Cool your hair down before final styling or applying hair
spray.
•
Avoid contact of heated surfaces with your face, neck
and other parts of your body.
•
After use set the power switch (3) to the position «0»,
the indicator (2) will go out; then take the power plug
out of the socket. Let the unit cool down.
IM VT-8285_70x130.indd 6
21.12.2018 14:28:04
