Vitek VT-8254, Manual Instruction, Page: 5 / 36

5
ENGLISH
– remove the batteries if you are not planning to use the
manicure set for a long time.
– apply to specialized centers for further recycling of the
batteries.
– avoid circuiting the power clamps.
USAGE
– Make sure that the operation mode switch (3) is set to
the position “0”.
– Install the required attachment (10, 11, 12, 13) to the
installation place (5).
– Use the operation mode switch (3) to set the required
attachment rotation speed:
«0» – the unit is off,
«1» – low speed, attachment rotation, the illumination (4)
lights up.
«2» – high speed, attachment rotation, the illumina-
tion (4) lights up.
ATTACHMENTS AND ACCESSORIES
Cuticle stick (7) , intended for manual cuticle lifting.
Cylindrical attachment (10) , intended for treating the
surface of thick fingernails.
Fine disc (11) , intended for treating rough skin. Move the
disc (11), gradually exfoliating the skin surface.
Large cone attachment (12) , intended for polishing rough
skin, corns, or for polishing nail surface. Carefully move the
attachment (12) over the treated skin or nail.
Felt disc for nail polishing (13) , intended for polishing
the nail surface.
– During the operation carefully move the attachment
along the treated surface.
– After you finish using the unit, set the switch (3) to the
position «0», the illumination (4) will go out.
– Remove the attachment (10, 11, 12, 13) from the motor
unit (2).
Nail polish dryer (9).
– Use the dryer after applying the nail polish. Put your hand
into the dryer (9) and press the fan switch-on button (8).
TIPS
Follow these recommendations to keep your nails healthy
and achieve good results when using the manicure set.
•
Avoid irritant chemicals getting on your nails.
•
Do not expose your hands to extreme cold. Always wear
gloves when it’s cold.
IM VT-8254_70x130.indd 5 8/14/18 16:39