Vitek VT-8228, Instruction Manual

Page: 5 / 36

5
ENGLISH
• Check the integrity of the power cord periodically.
• Do not use the unit if the power cord or plug is damaged,
if the unit works improperly or after it was dropped.
•
Do not attempt to repair the unit. Do not disassemble the
unit by yourself, if any malfunction is detected or after it
was dropped, unplug the unit and apply to any autho-
rized service center at the contact addresses given in
the warranty certificate and on the website www.vitek.ru.
•
To avoid damages, transport the unit in the original
package only.
•
Keep the unit in a dry cool place out of reach of chil-
dren and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY,
ITS COMMERCIAL USAGE AND USAGE IN PRODUCTION
AREAS AND WORK SPACES IS PROHIBITED.
USING THE HAIR DRYER
After unit transportation or storage at low tempera-
ture keep it for at least three hours at room tempera-
ture before switching on.
–
Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
– Remove any advertisement stickers that can hinder
the unit operation.
– Unwind the power cord completely.
– Insert the power plug into the mains socket.
– Select the required operation mode using the switch (1):
« 0 » – the hairdryer is switched off;
« I » – supply of warm air at low flow speed;
« II » – supply of hot air at maximal flow speed.
Note: During the first operation some foreign smell and
a small amount of smoke from the heating element is
possible, it is normal.
–
After unit operation, switch the hairdryer off by setting
the switch (1) to the position «
0 », and unplug it.
Nozzle
Use the nozzle (3) when you need to focus the power
of drying on a small area (for example, a curl or a wave)
or when you want to straighten wavy hair.
IM VT-8228_70x130.indd 5 29.08.2018 11:59:35