Vitek VT-6604 BK, Manual Instruction

Page: 6 / 48

6
ENGLISH
Once the mains voltage is restored, the unit is switched
to the mains power supply.
Note: The alarm sound signal will be on only if there is
power in the mains.
•
Open the battery compartment lid (19). Insert 2 «AAA»
batteries (not supplied with the unit), following the
polarity.
•
Close the battery compartment lid (19).
•
To connect the unit to the mains, insert the plug of the
power cord into the mains socket.
Attention!
Battery leakage can cause injuries or damage the unit.
To avoid damages, follow the recommendations specified
below:
– insert batteries following the polarity;
– remove the batteries if you are not planning to use the
unit for a long time.
– do not dismantle the batteries; do not expose them to
high temperatures;
– replace the batteries in time.
TIME SETTING
•
Plug the unit into the mains.
•
In the current time mode press and hold the button (1)
« PRESET/MEM » , blinking time indications will appear
on the display.
•
Consequently press or hold the button (2) « HOUR/
9
»
to set the necessary hour.
•
Consequently press or hold the button (3) « MIN/
:
» to
set the minutes.
•
To finish the setup procedure press the button (1)
« PRESET/MEM ».
Note: If the buttons (2) «HOUR/ 9 » or (3) «MIN/ : » are
not pressed within 10 seconds during the setup process,
the unit will be switched back to the current time mode .
Alarm setting (ALM1 and ALM2)
•
To view the alarm time, press the button (4) « ALM1 » or the
button (5) « ALM2 » respectively. The alarm time will appear
on the display. If no buttons are pressed within 10 seconds,
the unit will be switched to the current time mode.
•
In the current time mode press and hold the button
(4) « ALM1 » to set up the first alarm or the button (5)
« ALM2 » to set up the second alarm. Blinking alarm time
VT-6604_IM_70x130.indd 6 01.07.2015 17:24:16