9
ENGLISH
Step 5 – the final part
– In the final stage of hair cutting remove the attach-
ment comb from the unit, turn the blades of the clipper
towards the hair and trim hair on the temples and neck
carefully. Do not press the clipper strongly, there is dan-
ger of injuries or cuts when open blades come in contact
with skin (pic. 9).
Cone-shaped haircut
Set the necessary attachment comb and start cutting
from the head back towards the crown. Cut hair against
hair growth from the head front to the crown and from the
sides (pic. 10). To get a flat top haircut, use the comb: lift
the locks and cut them along the comb. Comb the hair to
reveal uneven locks.
After you finish cutting hair, switch the hair clipper off set-
ting the power switch (4) to the position «O» and take the
power plug out of the socket, put the protective cover (1)
on the blades.
CLEANING AND CARE
Lubricating the blades
Regularly lubricate the blades using the oil (11) supplied
with the unit.
– Switch the unit off using the power switch (4) and
unplug it.
– Apply one-two drops of oil (11) on the teeth of the blades
and the back side of the upper blade, switch the unit on
and make sure that the blades are moving smoothly.
– Switch the unit off, clean the excess oil with a dry cloth.
Attention! Use the oil (11) supplied with the unit.
DO NOT USE vegetable oil, fat, oil mixed with any solvents
for lubricating.
Solvents will evaporate, leaving thick grease that may slow
down the blades’ motion.
Cleaning the hair clipper
– Switch the hair clipper off and unplug it.
– Clean the blades from hair, using the cleaning
brush (12).
