Vitek VT-2296 BK, Instruction Manual

Page: 5 / 24

ENGLISH
5
•
Check the unit for damages; do not
use it in case of damages.
•
Before switching the unit on, make
sure that your home mains voltage
corresponds to the unit operating
voltage.
•
Install one of the attachments on the
unit body (8) so that the symbols «
▼
»
are above the attachment lock but-
tons (3). Then install the attachment
on the unit body (8). If the attachment
is set properly, you’ll hear the lock
buttons (3) clicking.
•
To remove the attachment, press
the attachment lock buttons (3) and
remove the attachment.
Note: Install or change the attach-
ments only when the unit is
unplugged.
•
Insert the power plug into the mains
socket.
•
Make sure that the switch (6) is in the
lower position «0».
•
Select the required mode using the
switch (6):
« 0 » – the unit is off;
– low speed;
– high speed.
•
Set the required air flow temperature
using the switch (5):
– «cool» air supply,
1 – medium heating;
2 – maximal heating.
Notes :
During the first operation some for-
eign smell and a small amount of
smoke from the heating element is
possible, this is normal.
If the unit is switched on with the
switch (6), the operation indicator (4)
will be lighting.
•
Wind a small lock on the brush.
•
Switch the unit on and dry your hair
for several seconds, adjusting the
air flow speed with the switch (6)
and the heating degree with the
switch (5).
•
Remove the lock from the brush.
•
This model has a «cool» air supply
function, use it to fix your hairstyle.
To switch the «cool shot» on, set the
switch (5) to the lower position «
».
•
After you finish styling, set the switch
(6) to the «0» position and unplug
the unit.
•
Place the unit on a flat heat-resistant
surface and let it cool down com-
pletely.
Notes:
Before making a break in operation,
switch the unit off with the switch and
put it on a flat heat-resistant surface.
Avoid contact of hot surfaces of the
unit with your face, neck or other
parts of your body.
Do not comb your hair right after styl-
ing, let it cool off. Carefully divide the
locks with your fingers to make them
look naturally.
Do not block the air inlet grid during
the use of the unit.
Avoid getting of hair into the air inlet
grid during operation of the unit.
Attachments
Flat brush (9)
The flat brush (9) creates the effect of
natural volume on hair of different length
and provides soft drying.
VT-2296_small.indd 5 16.01.2018 11:25:14