Vitek VT-2212 G, Manual Instruction

Page: 5 / 28

5
ENGLISH
– Check the unit for damages; do not use it in case of
damages.
– Wipe the body (1) and motor unit (8) with a soft, slightly
damp cloth and then wipe dry.
– Rub the accessories (2-7) with medical alcohol to dis-
infect them.
Battery installation and replacement
– Make sure that the operation mode switch (9) is set to
the position “0”.
– Remove the battery compartment lid (13) and insert
or replace 2 AA batteries, strictly following the po-
larity.
– Install the battery compartment lid (13) back to its place.
Notes: If there is an isolation insert in the battery compart-
ment, remove the battery compartment lid (13), remove
the isolation insert and install the battery compartment lid
(13) back to its place.
USAGE
– Make sure that the operation mode switch (9) is set to
the position “ 0 ”.
– Please note that the unit is powered by batteries
only. Before using the unit check whether the bat-
teries are installed in the battery compartement.
– Install the required attachment (2-7) on the installation
place (11).
We recommend to use:
•
coarse disc (7) to shape your nails;
•
fine disc (2) to finish shaping your nails;
• small cylindrical attachment (3) to treat skin around the
nails and to remove cuticles;
•
felt disc (4) for polishing the nail edge and surface and
adding gloss to your nails;
•
large cone attachement (5) to remove rough skin;
• small cone attachement (6) to treat nails;
– Use the operation mode switch (9) to set the required
attachment rotation speed:
«
0 » – the unit is off;
« R1 » – low speed, attachment rotates to the right, the
illumination (12) lights up;
VT-2212_IM_70x130.indd 5 25.10.2017 18:38:17