Vitec Videocom - Litepanels
www.litepanels.com
The SYSTEM SETTINGS menu allows you to check for systems information, giving you firmware version and chip IDs. You
can monitor the system input voltage, temperature, power out and fan RPM.
For Service or Rental operations there is a “SYSTEM TEST”. That will allow you to run through a series or procedures that
the screen walks you through, to basically troubleshoot the unit.
Tools Settings – SYSTEM Settings
Enter into TOOLS
settings
. Press Up
or Down button to
highlight SYSTEM.
Press OK
Press Up or Down
button to highlight
SYSTEM INFO. Press
OK
Displays the Light
system information
and firmware revision.
Press BACK.
Enter into SYSTEM
MONITOR menu . Press OK.
This now displays the
current functional state of
the light . Press BACK
Press Up or Down button
to highlight SYSTEM
TESTS. This is normally
only used by the QA &
Service departments, but
you can run them if you
have issues. Press OK
Press OK on SYSTEM TEST, and
the light will run self-diagnostics.
In less than 1 minute the display
will give PASS or FAIL result. If a
failure should occur, run the test
again to make sure it is not an
anomaly. If it fails again, contact
your local service dep’t. SYSTEM
BURN-IN is usually run after a
repair has been completed. Press
BACK.
Enter into SYSTEM
DEFAULTS menu . Press OK.
This now gives you the
choice to return to factory
settings. Once complete
Press BACK or OK
