background image

Problem

Possible Cause

Suggested Solution

Water dispenser 

Small pin hole or crack in the bottle,

Conduct water bottle leak test outlined 

or dispensing tap 

(common with recycled water bottles).

on page 4.

is leaking

Drain cap and silicone seal are not secure.

Ensure seal is secure in drain plug and
tighten drain cap.

Water was poured directly into bottle 

Drain by pressing dispenser taps.

support collar and overflowed.

Possible air pocket.

Press several times to relieve air pocket and
release to re-set valve.

Water is not hot or

All the water in the tank has been used.

Replace with full bottle and wait 30 

cold enough

minutes for the water to heat or cool. 

The unit is unplugged.

Plug it into the outlet.

Insta-HOT Feature was not activated.

Activate Insta-HOT Feature by pressing the button.

The circuit breaker in your home is

Reset the breaker or replace the fuse.

tripped or the fuse has blown.

Power switch not turned on at

Turn switch to the ON position.

back of unit.

Temperature limit tripped.

Set power switch to OFF position,
wait 5 minutes, then set power 
switch to the ON position. Wait 30 
minutes for the water to heat or cool.

Thermostat needs to be adjusted colder.

Adjust thermostat between min (cool) and max 
(colder) levels to achieve desired temperature.

Water dispenser 

Empty water bottle.

Replace with full bottle.

is not dispensing water

Mineral deposits clogging tanks.

See Cleaning the Reservoirs.

Possible air pocket.

Push down on the dispenser taps to prime 
the unit.

Possible ice build up due to thermostat

Unplug overnight, then reset. Set thermostat 

set too cold.

to MIN, slowly increasing based on your use 
and need for cold water. 

Water dispenser is noisy

Bottle making a gurgling noise as it

This is normal.

fills the tank.

Water dispenser is uneven.

Make sure the dispenser is on an even 
surface that can support its full weight.

TROUBLESHOOTING TIPS

SPECIFICATIONS

VWD5276W-BLK

Output per hr

Hot

1.2 gal / 4.6 L 

Cold

0.5 gal / 2.0 L

Internal Tank:

Hot

0.2 gal / 0.6 L

Cold

0.8 gal / 3.2 L  

Heating Temp (approx.):

194°F / 90°C

Cooling Temp (approx.):

46°F / 8°C

Power Consumption

Hot

1300 W

Cold

90 W

WARNING: The Water Dispenser
heats and dispenses water to 
194˚F / 90˚C which can cause severe
burns or scalding.

DO NOT ALLOW CHILDREN TO USE
THE HOT WATER DISPENSING 
BUTTON WITHOUT PROPER AND
DIRECT SUPERVISION.

7

Childproof

safety

lock

Summary of Contents for Classic VWD5276BLK










Reviews: