Vitals MASTER EST 5.8ba, Manual For Technical Use, Page: 9 / 48

1 7 1 6
5.1. GETTING STARTED
1. Before operating the unit automatic check the enclosure, cable,
automation, power cables, faulty indicator lights, fuses, terminals, connectors,
buttons «ON / OFF» and «START / STOP».
2. Check the performance of sub-paragraphs 5.2. "Preparing for work
"Manuals gasoline mini electrical power stations EST5.8ba.
3. Make sure that the key is «ON / OFF» is in the «OFF» (off).
4. Connect the power cables and automation according scheme (see
Fig. 3).
Connection order voltage monitoring relay (slam
voltage):
џ
connect one end of a two-wire power cable to the input L and N terminals of
the voltage monitoring relay and tighten clamping screw terminals;
џ the other end of the cable to the corresponding output terminals household
electrical panel: N - the "zero" bus, L - for automatic safety "out of phase
'(see Fig. 3). Securely tighten the clamping screw terminals.
How to connect the cable of automation:
џ connect one end automation (supplied with product) to the connector (7)
«GENERATOR» automation and control unit (see Fig. 2);
џ
the other end of the cable to the connector ATS (8) mini electrical power
stations EST5.8ba (see Fig. 1)
OPERATION OPERATION
5
ATTENTION !
When connecting the power cable, apply polarity.
WARNING!
As power cables, use two-conductor cables of appropriate
length with a cross section of each cores of at least 6 mm².
Terminals on the block have automatic marked: 'phase' is
marked as L, «zero» - the letter N.
NOTE !
Power cables and plug in the supplied power automatics are
not included.
WARNING!
To ensure correct operation of the automation in the unit
voltage fluctuations in the power supply is recommended
A relay control voltage (cut off voltage).
WARNING!
Rated current trip a circuit fuse must be 32 A. Rated current
circuit breaker is not exceed the permissible current loads for
wiring a home network.
WARNING!
Do not press the «START / STOP» if you plan start / stop the
engine power.