EN Instructions
Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
✆
+49 38851 314650 *)
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
All rights reserved.
Z 01773 M DS V1 0618
Inserting / Changing the Battery
Before inserting the battery, check whether the con-
tacts in the battery compartment (
3
) and on the battery
are clean, and clean them if necessary.
1. For this purpose, unscrew the lower section of the
housing in a clockwise direction and remove it from
the basic device (
5
).
2. If necessary remove any used battery and insert 1 x
1.5 V battery, AA type into the battery compartment
with the negative (minus) pole to the front.
3. Attach the lower section of the housing to the basic
device once more and turn it in an anti-clockwise
direction to
fi
x it into position.
Replace the battery when the power of the device starts
to become weaker.
Attaching / Removing Attachments
• To attach the attachment, place it on the basic
device (
5
) and turn it clockwise to
fi
x it into position.
• To remove the attachment again, turn it in an anti-
clockwise direction.
Application
PLEASE NOTE!
■
Do not use the device for longer than 60 seconds on
each treatment so that you do not irritate the skin on
the face too much.
■
When cleansing the face with the device, avoid the
area around the eyes.
PLEASE NOTE:
Treatment with the device can result in
slight reddening of the skin immediately after the treat-
ment. A warm or tingling sensation may occur during
the cleansing. Both the reddening and the sensation
will usually disappear after a few minutes. If the skin
should feel dry and
fl
aky and stay red for a prolonged
period of time, you may have pressed the device too
fi
rmly against your face or persisted on one spot for
too long. Try to exert less pressure and treat the cor-
responding spot for less time when you next use the de-
vice. If the symptoms persist over a prolonged period,
consult a doctor.
Cleansing the face
1. Moisten the face.
2. Attach the brush attachment (
6
) to the basic de-
vice (
5
).
3. Rinse the brush attachment under running water!
4. Apply a cleansing product to the face or the brush
attachment as required.
5. Press the On / Off switch (
4
) to switch on the device:
Press 1 x:
light vibration
Press 2 x:
strong vibration
Press 3 x:
Off
6. Move the brush attachment in a circular motion over
the face and massage the cleansing product into the
skin. We recommend: 20 seconds for the forehead,
20 seconds for the nose / chin and 10 seconds for
each cheek.
7. Press the On / Off switch until the device switches off.
8. Rinse the face with fresh water if a cleansing prod-
uct has been used.
9. Remove the brush attachment from the basic device.
PLEASE NOTE:
After some time the brush attachment
will become worn. Because worn bristles can irritate
the skin, we recommend regular replacement of the
brush attachment.
Applying cream and massaging
1. Attach the silicone attachment (
1
) to the basic de-
vice (
5
).
2. Apply a cleansing product to the face or the silicone
attachment as required.
3. Press the On / Off switch (
4
) to switch on the device:
Press 1 x:
light vibration
Press 2 x:
strong vibration
Press 3 x:
Off
4. Move the silicone attachment in a circular motion
over the face and massage the cleansing product
into the skin.
5. Press the On / Off switch until the device switches off.
Cleaning and Storage
PLEASE NOTE!
■
Do
not
clean the attachments in the dishwasher.
■
Do not use any corrosive or abrasive cleaning
agents to clean the device. These can damage the
surface.
■
Only ever dry the attachments in the air, and never
use a tumble dryer or a hair dryer to do this!
1. Remove the attachment used from the basic de-
vice (
5
).
2. Clean the attachment under hot running water and
allow it to dry in the air.
3. When necessary clean the basic device with a
moist cloth.
4. Store the device and accessories in a dry place
which is not accessible to children and animals.
Technical Data
Article number: 01773
Model number: RH-0156
Power supply:
1.5 V DC (1 x 1.5 V battery, Type AA)
Disposal
Dispose of the packaging material in an environ-
mentally friendly manner so that it can be recycled.
Dispose of the device in an environmentally
friendly manner at a recycling centre for used
electrical and electronic devices. It should not be
disposed of in the regular domestic waste.
The battery should be removed prior to disposal
of the device and disposed of separately from the
device at a suitable collection point.
Article number: 01773
