STEP 4
Attach the two chin up bar brackets (E) to the two upright beams (A) as shown by removing the pre-installed
acorn nuts and washers then placing the chin up bracket over the threaded bolts and re-installing
the washers and acorn nuts finger tight only. DO NOT FULLY TIGHTEN NUTS YET.
Insert the wood chin up bar (D) into the chin up bar brackets as shown below. DO NOT INSTALL THE WOOD
SCREWS YET.
T
O
P
Upright Beam
ASB3680C4
Chin Up Bracket
Acorn Nut
Flat Washer
Flat Washer
Mounting the assembled stall bar.
If assembled correctly, the wall mount standoff brackets will be spaced 32" apart allowing it to mount to standard
wood wall studs that are typically spaced 16" on center. once you have located your wood studs and with the help
of another person, stand the stall bar up against the wall and mark the spots where the stall bar will be bolted to
the wood studs. Pilot drill these eight locations with a 7/32" drill bit. NOTE: If you are not experienced in doing
this type of work you may want to consult a handyperson or professional for help. There is the possibility of
utilities within the wall that you will want to avoid.
Securely fasten stall bar to the wall with the supplied 5/16" x 2-1/2" lag bolts and washers (F)
If mounting to a metal stud wall you will need to first mount wood blocking spanning at least 3 studs for both
upper and lower wall mount brackets. If mounting to a concrete or masonry wall you will first need to install
lag shield anchors or other type of 5/16" min. anchor bolts. After all bolts are installed push on the supplied
decorative bolt head cover caps (H) If mounting to a metal stud wall, you will need to securely attach two
backer / blocking boards to the metal stud wall then attach the stall bar as described above.
TOP
TOP
Note: Mount chin up brackets
to the outside of upright beams.
Chin Up Bar (D)
STEP 5
Now that the stall bar is safely mounted to the wall, Adjust the chin up bar brackets to your desired height and securely
tighten both acorn nuts on both sides. Center the wood chin up bar between the two chin up bar brackets.
Pilot drill a 1/8" hole through the holes found on the bottom of each collar into the wood chin up bar and install the
supplied #10 x 3/4" black wood screws (G) (two per collar)
STEP 6 (Final)
Chin up bar collar
#10 x 3/4" Black wood screw
Equal Distance
To keep you new stall bar in top condition you may periodically treat the wood rungs with a light coat of Danish oil
or Linseed oil. Typically twice a year will suffice. Before each use please make sure all fasteners are tight and secure.
Vita Vibe, Inc. 40 Ellwood Ct. Greenville, SC 29607
Tel: 864-288-8934 Fax: 864-751-6302
Email: [email protected]
Please keep this assembly guide for future reference. Should you need assistance
with assembly or replacement parts contact us directly. Do not return to place of purchase.
Made in USA
