Chapter 10
Settings
The CueCore1’s settings are organised into sections, see the Settings page figure
10.1. This chapter will discuss each section.
Figure 10.1: Settings page
10.1
General
You can change the CueCore1’s label. This label can be used to distinguish the
unit in a set-up with multiple devices. By enabling the ’Blink’ checkbox the
device’s LED will blink to help to identify it amongst multiple devices.
This section also allows you to set the number of Memories in the Recorder.
By default this number is set to 16. If you would like to store only a few, but
33