Smart Tire Pressure Monitoring System
Installation Guide of internal sensor
Smart Tire Pressure Monitoring System
Installation Guide of internal sensor
C,Internal sensor installation
Please install configured receiver and sensors.
If there is wrong ID code or mix position of sensor,
please refer “learn code by inflate&deflate”
(detail please refer to use manual of receiver)
Please make sure receiver is open when installing sensor,
in this way, data could be sent to receiver immediately once sensor installed.
Detail process:
2,Picture of installation sensors
1,Remove the tire from vehicle, detached tire and rim, then clean inside of tire and rim.
2,Select internal sensor ,which is assembled ( valve) in advance, of corresponding tire's position
3,Install internal sensor accompanied with valve, make sure there is gap between sensor module and wheel.
Instead original valve with internal sensor, then put pad around valve and fasten fixing nut . shake the valve
gently up and down to make sure sensor closed to wheel finally screw fixing nut by tool.
(install sensor with plastic valve is same as install normal valve, just using tool to pull out valve. Please pay
attention there is distance between sensor module and wheel)
4,Inflate tire after installed sensor, and check leakage by using foam, ensure no leakage
5,Adjust lead weight and do balance of wheel
6,Installation other sensors by same method
Jack up car, remove tire
Detach tire and rim
Cut off the original valve
(do not scratch wheel)
Insert sensor
Pull out of the valve with
special tools(only for plastic valve)
Ensure gas nozzle is close to rim, and
mount pad, fastening nut one by one
( only for aluminum valve)
Inflate to standard pressure
after installed
Adjust the lead weight
Do balance
F
F
.
L
D
F.L
E
