VISTEON VNMC-1000, Owner'S Manual

Page: 51 / 59

Appendix
- 51 -
19. Appendix
„
Trouble Shooting
If the problem continues after performing the following actions, please
contact
the place of purchase or customer support center (***-****-****).
• DVD Player
Message Symptom Action
Please
Check Disc When the unit can not
read the disk.
Clean the disk or
replace it with another
disk.
Err 0
When the temperature
of DVD Loader is no
less than 75 degrees. Turn off the power of
this product and adjust
the temperature.
Err 1
When the temperature
of DVD Loader is not
more than – 30 degrees. Turn off the power of
this product and adjust
the temperature.
Err 5
When the spindle motor
does not work properly. Turn off and on the
power again.
Tray Error
When the tray is locked
because of an inserted
disc.
Turn off and on the
power again. Take out
the disk forcefully by
pushing and holding the
[ ] button for a few
seconds.
Input Invalid
When pushing a button
or icon incorrectly.
Play Back Only
When entering a playback
command not supported in
the current mode.
Push the correct button
or icon.
•
General
Symptom Cause Action
Power does not turn
on.
Fuse has blown.
Replace with a fuse of
same amperage. If the
fuse blow again,
consult
with the dealer from
whom you purchased
the unit.
The operating
environment is too cold
or too hot.
Operate the unit at room
temperature.
Nothing happens
when buttons are
pressed. Display is
not accurate.
The microprocessor has
malfunctioned due to
electrical noise, static or
other causes.
Turn off the unit and
then power it up again.
Touch screen is not
working properly. The touch screen is
incorrectly aligned.
Adjust the touch screen
sensitivity of the LCD
screen.
Sunlight is interfering
with the remote control
IR Sensor.
Try use this unit where
there in no direct
sunlight hitting the
sensor.
The remote control
does not work.
Batteries of remote
control are dead or there
is no battery in the
remote control.
Check and/or replace
the batteries in the
remote control unit.