P a g e
|
3
Safety Instructions
Read this operating manual completely before using the device for the first time. Also, observe the instructions for use of the
accessories. This instrument may sometimes be used with hazardous materials, operations, and equipment. It is beyond the scope
of this manual to address all the potential safety risks associated with its use in such applications. It is the responsibility of the
user of this instrument to consult and establish appropriate safety and health practices and determine the applicability of
regulatory limitations prior to use
.
ali-Q
is an aliquoting pipet controller designed for aspirating and dispensing aqueous solutions with plastic or glass serological
pipets in
1
to 100 mL volumes. It is intended for laboratory use. Any use of this instrument in a medical or IVD setting is the sole
responsibility
of
the user.
! Please read the following carefully!
1.
Every user must read and understand this operating manual before operation.
2.
Follow general instructions for hazard prevention and safety instructions; e.g., wear protective clothing, eye protection and
gloves.
3.
Observe all specifications provided by reagent manufacturers.
4.
Never use the instrument in an atmosphere with a danger of explosion. Highly flammable liquids must not be pipetted.
5.
Only
use the instrument for pipetting liquids, with strict regard to the defined limitations of use. If in doubt, contact VistaLab.
6.
Always use the instrument in such a way that neither the user nor any other person is endangered. Avoid splashes. Only use
suitable vessels.
7.
Never use force on the instrument.
8.
Use only VistaLab accessories and spare parts. See Ordering Information on pg 18. Do not attempt to make any technical
alterations. Do not dismantle the instrument any further than is described in the operating manual!
9.
Always check the instrument for visible damage before use. If there is a sign of a potential malfunction, immediately stop
pipetting. Consult the 'Troubleshooting' section of this manual or contact VistaLab if needed.
10.
Only the original Power supply can be used for recharging of the Lithium Ion battery. Do not replace with non-rechargeable
batteries or rechargeable batteries of other manufacturers.
11.
The Power supply must be protected against moisture and must be used only for this instrument.
12.
Only authorized service personnel may service the instrument. Unauthorized repair or service may void the units’ warranty
13.
DO NOT AUTOCLAVE ali-Q. Only approved parts and accessories may be removed from unit for autoclaving. See pg. 12,
Cleaning / Decontaminating.
14.
WARNING! Improper use of the instrument or the battery (short-circuit, mechanical damage, overheating etc.) may cause
the
explosion of the battery.
Operating Conditions:
o
Operating Temp: 15°C to 40°C (59°F to 104°F)
o
Storage Temp: -20°C to + 50°C (-4°F to +122°F)
o
Altitude up to 2000 m
o
Relative Humidity: 10% – 95%, non-condensing
o
Atmospheric Pressure: 70 – 106 kPa (525 – 795 mmHg)
o
Vapor Pressure up to max. 500 mbar. Aspirate slowly above 300 mbar, to prevent liquid boiling
o
Density up to 9.0 g/cm
3
ali-Q Body Chemical Compatibility for cleaning and decontaminating:
Water, diluted ethanol or isopropanol. For more information on chemical compatibility, see the support area of our website,
www.vistalab.com/support
Safety Compliance:
See Declaration of Conformity at end of manual
EN 61010-1 General Safety Requirements
CSA C22.2, No. 61010.1
EN 61326 EMC Requirements
UL 31111-1
<-
Back to T
.
O
.
C
.
