www.vistacnc.com
- 6 -
www.vistacnc.com
- 6 -
iMach
III
P1 Pendant Manual v. 3.2
•
Number in
is used to adjust the sensitivity of
mode. The smaller the number, the
less turns are needed to reach maximum speed.
•
Number in
is the feed rate used in MPG step jogging. When MPG wheel stops, the feed
rate and FeedRate Overridden rate (FRO) will automatically change back to the number which
was used before MPG moving. Input 0 is to use current FeedRate and FRO rate in the system
in MPG step jogging.
•
Steps to Delay Start in
is used to set up a step number. Axis starts to move only after that
many steps are turned from MPG wheel.
•
Number in TAB Screen Display Time in
is to set up the TAB screen stay time in
seconds. The TAB screen will close if the stay time is reached or if MPG mode is moved to a
mode other than
mode. Put 0 to skip the TAB screen.
SPECIFICATIONS
Work with Mach3 R2.63 and above.
36 steps (clicks) per Rev MPG.
200,000 cycle life MPG.
Shipped with10' High Speed USB cable. Extendable to 15’ with extension cable, and to 45’
with USB hub cables.
Size (over all) 5.1"(L) x 3.1"(W) X 2.1"(H)
