7
Chapter 2
— Installation and Configuration
2.1 Package Contents
Installation of the camera must be performed by qualified service personnel in accordance with all
local and national electrical and mechanical codes.
Carefully remove the colour camera and its accessories from the carton and verify that they were
not damaged in shipment.
The content of the package includes:
1. Camera 2. Fixings
3. Instruction manual 4. Template sheet
5. DC Jack
2.2 Mounting the Camera
CAUTION: When installing the camera outdoors, the following instructions must be
followed closely.
1. Loosen the four Torx screws on the housing cover. These are captive so there is no need to
remove completely.
2. Use the mounting template as a drilling guide to ensure correct positioning of the screws.
3. Drill 4 holes into the mounting template. Insert the screw raw plugs (anchors) and attach the
housing using the 4 x M6 Torx screws.
NOTES:
If the 2.1mm jack adaptor is not used then please ensure the correct polarity is
observed when 12VDC is being used. The terminals are colour coded to assist:
Red = 12VDC / Black = 0V
If the camera is being installed externally, please ensure the side ¾” NPT thread is
sealed with Teflon tape or suitable sealant.
There are 2 photocells on the LED array in IR models and the cap is pre-fitted to one
of these. To reduce any hunting effect, please place the cover over the photocell that
is closer to being angled/located inside the housing.
