Major operating controls and functions
1. DC12V Input Terminal: For connected to power supply.
2. Video Output Connector (VIDEO OUT): For connected to video terminal.
3. To remove lens cover turn cover anti clockwise, to adjust the focus loosen the locking ring then turn
∞
←→
N before relocking the ring. Loosen the locking screw to adjust the Tel/wide T
←→
W before relocking
the screw. Ensure that the lens cover is returned to it’s tight position to ensure the integrity of the seal.
Connections
1. Connect to the power cord:
This is to connect camera to a 12V DC regulated power supply. (2.1mm centre positive)
2. Connect to video input:
This is to connect camera to 75
Ω
video terminal CCTV quality 75
Ω
coaxial cable via a BNC connector
Standard Accessories
1. Main Body (1)
2. DC-BNC Connector (1)
3. Instruction Manual (1)
4. Mounting bracket (1) and screws (3)
Vista
1. A regulated DC 12V power supply is recommended for use with this camera for the
best picture and most stable operation. An unregulated power supply can cause
damage to the camera.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75
ohm video impedance level. If your monitor is switched to high impedance then please
adjust accordingly.
3. Apart from removing lens cover for lens adjust. Do not attempt to disassemble the
camera to gain access to the internal components. Refer servicing to your dealer.
4.
Never face the camera towards the sun or any bright or reflective light, which may
cause smear on the picture and possible damage to the CCD.
Norbain House
Eskdale Road
Winnersh Triangle
WOKINGHAM
Berkshire
RG41 5TS
Tel:
+44 (0) 118 944 0123
Fax:
+44 (0) 118 944 0999
www.vista-cctv.com
