2
Ref: VPSU12xyEXTe
3)
The low voltage output cable must be correctly sized to carry the rated load current to the devices
connected to the PSU.
4)
Mains input and low voltage output cables should be routed to use different entry/exit holes in
enclosure.
5)
To comply with current BS EN60950 safety legislation the supplied cable ties must be used to secure
mains input and low voltage output wiring.
O
PERATION
This unit is intended for use by Service Personnel only - There are NO USER SERVICEABLE parts inside.
The green Mains LED will be illuminated whilst the mains supply is present. In the event of a fault
condition, the red Fault LED will also be illuminated on the module.
M
AINTENANCE
There is no regular maintenance required of this PSU.
If the output of the PSU fails the cause of the failure should be investigated e.g. short circuit load. The
fault should be rectified before restoring power to the PSU. The fuse(s) may need to be replaced on the
single output versions. Ensure the correct fuse rating and type is used.
D
ISPOSAL OF
P
RODUCT AT
E
ND OF
L
IFE
This product falls within the scope of EU Directives 2012/19/EU Waste Electrical and Electronic
Equipment (WEEE). At the end of life, the product must be separated from the domestic waste stream
and disposed via an appropriate approved WEEE disposal route in accordance with all national and local
regulations.
For more information see: www.recyclethis.info
