6
Insert two rear screws only & screw-in
only halfway!
1 and 2 HDD Chassis
1.
Loosen the screws on the rear and side panel (below) then remove
the upper cover.
Rear Panel
Side Panel
2.
Insert just the two rear screws in the HDD - those closest to the
power and data connectors as indicated below. Screw them in only
halfway!
3.
Offer the HDD into the base of the chassis and engage the two
screwheads into the two keyholes in the bottom of the chassis
–
refer to the image of the underside of chassis below.
4.
Slide the disk into
place so the two screwheads move from position
A to the lock position B in the keyholes (below). Now insert and
tighten the two remaining screws into the HDD from the underside of
the chassis and finally tighten the two screws in the keyhole position.
