IMPORTANT SAFETY INSTRUCTIONS - THE LIGHTED LAMP IS HOT!
CAUTION:
Do not exceed maximum wattage marked on
luminaire label.
1. To prevent electrical shock, disconnect from electrical
supply before service.
2. Loosen screw from shroud.
3. Remove shroud and gasket to expose lamp.
4. Replace lamp with correct wattage and type marked on
fixture label.
NOTE: DO NOT
touch lamp with bare hands. Always use soft
cloth or the plastic wrapping (if available) to handle the
lamp.
5. Re-install shroud and
gasket and tighten shroud screws
.
INSTALLATION INSTRUCTIONS
LAMP INSTALLATION/REPLACEMENT:
1092 11.16
WARNING: TO REDUCE THE RISK OF FIRE, OR INJURY TO
PERSONS:
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamps get hot quickly! Contact only switch/plug when turning on.
3. Do not touch hot lens, guard or enclosure.
4. Keep lamp away from material that may burn.
5. Do not touch the lamp at any time. Use a soft cloth. Oil from the skin
may damage lamp.
6. Do not operate luminaire fitting with a missing or damaged cover.
SAVE THESE INSTRUCTIONS
(Leave with property owner/manager)
Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.
1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478)
FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com
