INSTALLATION INSTRUCTIONS
WARNING:
Luminaire must be installed and grounded in accordance with the National Electrical Code (NEC) and local codes. For
portable stake or surface mount using a cord and plug, the luminaire must be plugged into a receptacle protected by a ground
fault circuit interrupter (GFI). Failure to do so may result in serious injury and/or damage to the luminaire.
MAINTENANCE
: To assure proper operation and efficiency and to prevent luminaire overheating, lens must be kept clean and
free of dirt, dust, leaves, trash and mineral deposits from water. A regular schedule maintenance program is recommended.
SAFETY WARNING:
Luminaire can become very hot depending on the lamp wattage used. Lens and housing around the lamp
can become hot enough to blister hands. Particular care should be taken not to locate luminaires where small children can reach
them if high wattage lamps are used.
NOTE:
Always use UL recognized wire connectors for connections.
NOTE:
Save these instructions for future reference.
LUMINAIRE IS UL LISTED FOR ABOVE GRADE INSTALLATION ONLY.
1. Make sure electrical supply is off at circuit breaker
before starting luminaire installation or servicing
luminaire.
2. Thread luminaire onto junction box or other mounting
device until it is at desired direction using thread sealant.
Tighten jam nut (provided) to ensure the luminaire is
locked to adjusted position.
3. Attach luminaire leads to line in leads observing polarity,
black to black, white to white and green to ground using
silicone filled safety connectors (provided).
4. Attach junction box cover with luminaire to junction
box (by others). Make sure not to pinch wires that may be
sandwiched between cover and box.
5. Coat exposed luminaire threads with thread sealant to
keep moisture from entering junction box or other
mounting device.
6. To adjust luminaire aiming angle, untighten adjustable
knuckle screw. Do not disengage totally. Hold luminaire at
selected angle and tighten knuckle screw firmly.
7. Install lamp.
8. Coat all exposed screws with silicone grease.
9. Supply power to the luminaire and check for proper
operation.
Vista Professional Outdoor Lighting reserves the right to modify the design and/or
construction of the fixture shown without further notification.
LUMINAIRE MOUNTING:
Lamp Information
Cat No
Lamp Type
Max Watts
1092
R30, PAR30
Incandescent or HID
75
Up & Accent Lights
Architectural Series
1092
Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.
1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478)
FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com
