OPERATING INSTRUCTIONS
Demonstration Kit
PDK-250
1. Open cap at top of
transformer stand and
remove transformer stand
legs from inside. Insert legs
into the appropriate slots
in the bottom of stand.
4. Connect low voltage
cable to transformer lead
using quick connect.
Lay cable out toward
area where fixture is to be
placed – use additional
quick-connect cables as
necessary.
3. Place transformer near
an AC power source
(outlet) and plug in.
5. Screw DK-2216 uplight
into ground stake then
place and adjust fixture
to desired beam location
and angle. Connect low
voltage cable to fixture
lead using quick connect.
6. Return to transformer
and switch ‘on’ using
power switch located on
bottom of transformer.
7. For testing or
immediate operation in
daylight, use included
cap to cover photocell.
Otherwise transformer
will operate on a ‘dusk to
dawn’ basis.
Basic Assembly and Operation
2. Secure legs
with thumbscrews.
(Replacement
thumbscrews are
included in case of loss or
damage.)
1625 Surveyor Avenue
•
Simi Valley, CA 93063
•
(805) 527-0987
•
(800) 766-VISTA (8478)
FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com
Precautions
•Do not exceed 250 Watts in total when connecting luminaires to the system.
•Luminaire can become very hot depending on lamp wattage used. Lens and metal around lamp can become hot
enough to blister hands.
•Vista Professional Outdoor Lighting assumes no responsibility for the improper installation of its products or for labor costs
involved in repair or replacement. In addition, Vista Professional Outdoor lighting shall not be liable to the purchaser or end
user for indirect or consequential damages.
