WWW.VISTAACOUSTICS.CA
VW6
Mounting Depth
3.1in - 78mm
Mounting Cutout
7.35in X 10.8in
187mm - 274mm
Overall Diameter
8.7in x 12.1in
220mm x 307mm
Power Handling
100 Watts
Frequency Response
50Hz to 20kHz
Nominal Impedance
8 ohm
Crossover Slope
24dB Acoustical
Pivoting Tweeter
25mm Silk Dome
Specifications subject to change.
8:
(Optional): Speaker performance can be enhanced by insulating the cavity
with fiberglass insulation. When installing speakers in a ceiling, it is best to install a
sheet of fiberglass insulation behind and around the back of the speaker.
9:
Pull the cable slack through the hole in the ceiling and strip off the outer
jacket. Strip about ½” of insulation off the ends of the wires. Connect the positive
wire from the amplifier to the red terminal on the speaker. Connect the negative wire
to the black terminal on the speaker.
Note: Make sure the power is turned off on your amplifier or receiver before con-
necting the speakers.
10:
Remove the speaker grill using provided tool. Place the speaker into the cut-
out in the wall. See figure D.
11:
Tighten the dogleg mounting screws evenly until the speaker is flat against
the ceiling. If you are using a drill to tighten the screws, be sure to set the drill to its
lowest torque setting.
12:
Make the final adjustments to the pivoting tweeter and reinsert the grill into
the speaker baffle.
VISTA ACOUSTICS VW6 OWNER’S MANUAL
Figure D: Install the speaker
Vista Acoustics® warrants to the original purchaser of this product that should the product or any part thereof be proven defective in material or workmanship within a period of 1 year
from date of purchase by original purchaser, such defects will be repaired or replaced, at the Company’s option, without charge for parts or labor.
THIS WARRANTY DOES NOT APPLY TO ANY PRODUCT OR PART THEREOF WHICH HAS BEEN DAMAGED THROUGH ALTERATION, MISHANDLING, MISUSE, NEGLECT, ACCIDENT,
IMPROPER INSTALLATION OR UNAUTHORIZED REPAIR.THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY AND ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WITHOUT LIMITATION THE IMPLIED WARRANTIES OR MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND ANY OBLIGATION, LIABILITY, RIGHT, CLAIM OR REMEDY
IN CONTRACT OR TORT, WHETHER OR NOT ARISING FROM THE COMPANY’S NEGLIGENCE, ACTUAL OR IMPUTED. NO PERSON OR REPRESENTATIVE IS AUTHORIZED TO ASSUME FOR
THE COMPANY ANY OTHER LIABILITY IN CONNECTION WITH THE SALE OF THIS PRODUCT. IN NO EVENT SHALL COMPANY BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAM-
AGES.
GRILL AND TRIM
PAINTING INSTRUCTIONS:
1. Don’t paint speakers while installed. Be sure they
are removed.
2. Remove the grill and paint seperately with two light
coats.
3. Using scissors cut out the paint shield template pro-
vided with speakers. Place paint shield over the speak-
er area, so no paint will get on the cone or tweeter.
Paint the trim using same method as the grill.
VW6 SPECIFICATIONS:
