Viss PL-1000, Owner'S Manual

Page: 19 / 32

6.2
* If you don’t lift the applicator out of device,
you won’t adjust the level.
Operation
1. Put on safety glasses.
2. Turn unit ON (main power switch &
power button).
3. Lift applicator out of its cradle and set
the appropriate intensity see ‘Setting
light intensity’ section (Ch. 6.2).
4. Place applicator on the desired area
making sure the silver sensor is placed
firmly against the skin (fig. 1), the device
will not flash unless in proper contact
with skin. (fig. 2)
5. Once a beep is heard and the green
‘ready to flash’ indicator light is ON, the
pulse is charged. (fig. 3)
6. Press the flash button.
7. Unit will take 3.5 seconds to charge, at
that time a beep will be heard and ready
to flash indicator light will be ON.
8. Move over area slightly overlapping, the
9. As long as it feels comfortable (not painful), increase the setting
by one level and apply one flash for each setting.
10. Never flash the same area twice without lifting the device
off the skin. This prevents excessive heating and possible
burning of the skin
slight indentation in the skin should be
used as a guideline.
(fig. 1)
(fig. 2)
(fig. 3)