D-302722
3
The procedure for deleting devices enrolled to the repeater is
performed for
all the devices collectively
. It is not possible to
clear a specific device from the MCX-610 memory.
A.
Remove the MCX-610 cover.
B.
Press the repeater’s enroll button continuously. In response,
the following successive stages should be observed:
i) The orange LED blinks and the buzzer beeps at a slow
rate (3 sec.).
ii) The red LED blinks and the buzzer beeps at a slow rate
(12 sec.).
iii) The red LED blinks and the buzzer beeps at a fast rate
(5 sec.).
At the end of the procedure, the red LED will light steadily for
3 sec. and a "happy" beep will sound to indicate successful
deletion of all devices
4.5 Local Diagnostics Test
This function allows you to test the signal strength of the enrolled
devices as seen by the repeater. Before testing, separate the
base from the cover (see Fig. 3).
Caution!
Local diagnostic test procedure must be performed
without the cover.
Press the repeater’s test button for 5 seconds; the green LED
blinks for 10 minutes or until the tamper switch is restored.
Three reception levels are sensed and indicated as illustrated in
the table below.
Received Signal Strength Indication:
Reception Buzzer
Response
Strong
Happy Tune twice ( - - - –––– ) ( - - - ––––)
Good
Happy Tune ( - - - –––– )
Poor
Sad tune ( –––––––– )
IMPORTANT!
Reliable reception must be assured. Therefore,
"poor" signal strength is not acceptable. If you receive a "poor"
signal from the device, re-locate it and re-test until a "good" or
"strong" signal strength is received.
4.6 Cover Closure
See figure 4.
1
2
Figure 4 - Cover Closure
5. NOTES AND WARNINGS
5.1 Product Limitations
Visonic Ltd. wireless systems are very reliable and are tested to
high standards. However there are some limitations to be
considered:
A.
Receivers may be blocked by radio signals occurring on or
near their operating frequencies
B.
Wireless equipment should be tested regularly to determine
whether there are sources of interference and to protect
against faults.
5.2 Compliance with Standards
Interference Prevention
This device complies with FCC Rules Part 15. Operation is
subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
that may be received or that may cause undesired operation.
WARNING!
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The digital circuitry of this device has been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential
installations. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio and television reception. However, there is no guarantee
that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by
turning the device off and on, the user is encouraged to eliminate
the interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the
one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
This device complies with the essential requirements and
provisions of Directive 1999/5/EC of the European Parliament and
of the Council of 9 March 1999 on radio and telecommunications
terminal equipment.
