Vislink Strata RX, Technical Reference Manual

Page: 53 / 186

Routine Operation 3-25
Strata RX
Operator’s Guide/Tech Ref Manual
3.5.7 Setting the COFDM Bandwidth
The COFDM Bandwidth
must
be set to match the bandwidth
used by the transmitted signal.
The RX will not automatically
set this parameter.
COFDM Bandwidth only operates when the RX is operating in
Digital mode.
To set the COFDM Bandwidth, follow these steps:
Be sure Strata is connected and
powered. See “Setting Up” and
“Turning the power ON and OFF”.
Start at the Main Screen.
Turn the Control Switch LEFT until the
display reads
Set OFDM BW.
Push the Control Switch to select
Set OFDM BW.
The current
Bandwidth setting begins to blink.
Turn the Control Switch LEFT until the
desired Bandwidth is displayed.
The choices are:
• 6 MHz
• 7 MHz
• 8 MHz
Preset #3
-43.2 dBm
Push the Control Switch to select that
Bandwidth.
Display indicates the new setting,
then changes back to the Main
Screen after the default delay.