Vislink Strata RX, Technical Reference Manual

Page: 36 / 186

Routine Operation 3-8
Strata RX
Operator’s Guide/Tech Ref Manual
Figure 3-6: Complete Tripod Installation
3.3.2 Turning the power ON and OFF
1. Be sure the Strata system is connected to power and
the RXU and RCU are connected. See the section
“
Setting Up
”.
2. To turn power on, flip the Power switch on the RXU
(and RCU, if present) to the “ON” position (
I
).
3. The normal power-up sequence is as follows:
Mounting
Bracket
RXU
RCU
Antenna
Lock Plate
Antenna
Quick
Release
Vislink
Tripod
- The LED above the power switch should illuminate
and change colors from red, to green, to amber, and
finally green.
- The display should light up and display first a self-test
screen, then the version of the installed firmware, and
finally the Main Screen.
Some typical screens are given in Figure 3-7.
The exact screens will vary depending on installed
hardware.
- The RX System will typically power up using the last
settings in use when power was turned off.
If the Strata RX does not power up normally, refer to
the “Troubleshooting” chapter.
4. To turn power off, flip the Power switch to the “OFF”
position (
O
).
Figure 3-7: Typical Power-up Screens
Preset#3
Squelch
Strata RXU
v 0.1.1
Firmware
Version
Main Screen
(
Analog
Mode)
Preset#3
-38.9 dBm LQ7
Main Screen
(
Digital
Mode)
OR