Vislink Strata RX, Technical Reference Manual

Page: 51 / 186

Routine Operation 3-23
Strata RX
Operator’s Guide/Tech Ref Manual
3.5.5 Setting the Monitor Output
If your RXU or RCU includes a COFDM demodulator, the
System allows you to select the output that appears at the
“MON.” (Monitor) connector. This output can be either:
• the 70 MHz IF input to the COFDM demodulator
• the ASI output of the COFDM demodulator
If your RXU or RCU does NOT contain a COFDM demodulator,
or if your RX is operating in Analog mode, the Monitor connector
will always provide the 70 MHz IF.
If your RX System contains both an RXU and an RCU with
COFDM, the Monitor connectors on the two units provide the
following:
• RXU
- Monitor always provides 70 MHz IF
• RCU
- Monitor is switchable between 70 MHz IF and ASI
To select the Monitor output, follow these steps:
Be sure Strata is connected and
powered. See “Setting Up” and
“Turning the power ON and OFF”.
Start at the Main Screen.
Preset #3
-43.2 dBm
Note If your RX System contains only an analog
demodulator, the front panel menus will still show
the
Set Monitor
choice. However that choice will
not operate and should be ignored.
Turn the Control Switch LEFT until the
display reads
Set Monitor.
The display will also indicate
70MHz
or
ASI
.
Push the Control Switch to change
the Monitor setting.
Display indicates the new setting,
then changes back to the Main
Screen after the default delay.