Vislink Strata RX, Technical Reference Manual

Page: 31 / 186

Routine Operation 3-3
Strata RX
Operator’s Guide/Tech Ref Manual
Pushing
the Control Switch
in
causes an
action
to occur.
Command Screens
• If the displayed setting is one of several choices,
pushing the Switch causes the displayed setting to
blink.
Turning the Control Switch then displays the other
choices for that setting.
When the desired choice is displayed, pressing the
Control Switch again selects that choice.
• If the displayed setting is one of only two choices,
pushing the Switch causes the setting to switch to
the other choice (e.g., if A is displayed, pushing in
the Control Switch selects B).
Monitor Screens
• Pushing the Switch locks the current screen on the
display (the display will not default to the Main
Screen).
• Pushing the Switch again unlocks the display, and
allows it to default to the Main Screen.
3.2.5 Using the Strata RX Screens
As you use your Strata RX, you will interact extensively with the
screens and menus. Following are some points to make this
easier.
Main Screen
The Main Screen is your starting point for
navigating through the Monitor and Command screens. The
Main Screen provides the current values of Preset, signal
strength, and Link Quality.
When the Strata RX is finished its power-up sequence, it will
display the Main Screen.
Typical Main Screens are shown in Figure 3-1.
Figure 3-1: Typical Main Screens
Accessing the Main Screen
You can access the Main Screen
at any time by scrolling to the end of the screens you are viewing
(either Monitor or Command). Your next click of the Control
Switch will bring up the Main Screen. See “Front Panel Menu
Maps” on page 3-27.
Default to Main Screen
If you do not turn or push the Control
Preset#3
-43.2 dBm
Preset#3
-43.2 dBm LQ7
Analog
Mode Digital
Mode
Currently selected Preset
Current signal
strength
Current Link Quality