Vislink Strata RX, Technical Reference Manual

Page: 163 / 186

Configurator Reference C-13
Strata RX
Technical Reference Manual
C.4.7 Channel Plan Page
The Channel Plan Page is show in Figure C-14. This is the page
that displays when you click on the
Channel Plan
tab.
You will use this Page to define the frequencies to be used by
each available channel and offset, for each band your RX is
equipped to use.
Band
To set the
Currently Selected Band
, click on the drop-
down arrow and click on the desired band. The bands available
will be configured at the factory when your radio is built. After
that, the Configurator will store the channel plan settings it had in
effect when it last connected to a radio. It will then recall those
settings when the Configurator is next run.
Channel
For each
Channel
in that Band, you can enter:
• The
Center
frequency.
• The
Offset (-)
and
Offset (+)
frequencies.
• The
Offset (++)
frequency (available depending on band).
Requirements for Entering Frequencies
Note the following
requirements when entering frequencies:
• The frequencies must be within the specified band edges.
An entry outside of the defined band will default to the
upper band edge (e.g., 2500 MHz).
• Frequencies must be entered in MHz, with the smallest
increment of 10 KHz.
• Frequencies must follow the format shown, with no
spaces or alphabetic characters.
The decimal separator
must be ì .î not ì ,î . If your computer is configured to
use ì ,î as the decimal separator, see ì Configurator
Troubleshootingî on page C-17.
• All fields must be filled - leave no blank fields.
Manage the Channel Plan
In addition, you can take the
following actions:
• Clear Channel Plan
- Erases all entries for all Channels. Used when you
want to enter a custom channel plan.
• Default FCC Channel Plan
- Fills the entries with the US frequencies approved by
the FCC for that Band.
• Load Plan from File
- Loads in a Channel Plan you have previously saved to
a file on your PC.
• Save Plan to File
- Saves the currently displayed Channel Plan to a file on
your PC. The default directory is “My Documents”.
Figure C-14: Channel Plan Page