© 2019
Step 2 of 2
Order #XXXXX
Cabinet Top
Velcro
Sintra
Light Blocker
Shelf
Align hole with pin
Rotate pin. Spring
will push pin into hole.
Cabinet Top Attachment
1
2
*
Pin
Hole
*
*
Steps:
1) Connect light blocker to Velcro on interior of assembled frame.
2) Attach assembled frame to verticals [3] and [3A].
See
Frame Attachment
detail.
3) Install SEG graphic to front of assembled frame.
See
SEG Graphic Installation
detail.
4) Place shelf inside assembled base on top of pins and supports.
5) Place cabinet top on assembled base, then secure with pins.
See
Cabinet Top Attachment
detail.
Completed Assembly
SEG Graphic
3
3A
Attach frame to
connector on
vertical extrusion,
using bolt.
Frame Attachment
Bolt
Connector
*
*
*
*
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
SEG Graphic Installation
It is important to first insert
graphic into each alternate
corner then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C
MOD-1700 Assembly (Cont’d)
