Vision Express Engraver S5 Installation Guide
18
© 2018 Vision Engraving & Routing Systems
3
Machine Setup
On the rear of the Express, there are four connection ports. The input power, the RJ-45 Ethernet port, the
USB port and the remote vacuum chip removal system on/off port.
Connect the power supply cord to a 100 - 240 volt AC power source. Then plug the power cable into the
port on the back of the machine. Plug one side of the network cable (black network cable) to the back of
the machine and the other side to either the PC Ethernet port, a network switch box or a company
network port.
NOTE:
The Ethernet crossover cable is gray and should not be needed.
If the emergency stop screen appears on the LCD when the machine is powered on, then the emergency
stop button is pressed in. Release the button twisting it until it "pops up". This will clear the emergency
stop screen.
The Express IP address configuration setup will vary depending on how it is connected to the PC.
The two options for connecting the Express to the computer are:
·
Direct connection to the computer or direct connection using a network hub or switch. Both of these
