Vision.net Photocell Daylighting Sensor
Installation & Operation Guide
9
Step 2a. Select Response Time buttons1-8:
1 – 1 min – Most aggressive for Dimmer Raise/Lower Control
2 – 3 min
3 – 5 min
4 – 10 min
5 – 15 min
6 – 20 min
7 – 25 min
8 – 30 min – Slowest for Dimmer Raise/Lower Control
0 – Factory Default (5 min)
Note:
For DH1 Mode, the Response Time is the time the sunlight is either below the Low
Sunlight setting or above the High Sunlight setting before RLYS Button ON/OFF commands
are transmitted.
Note:
For DH2 and DH3 Modes, the Response Time selects how rapidly the dimmers are
adjusted with a change in light. Response times will vary based on how much and how rapid
the light changes. The dimmers can respond in as little as 5 seconds or as much as 30 minutes.
Step 3. Tap AV (C) to select the AV Button Input(s) to control when in DH1 Mode. Tap AV
(C) to select the AV Button Input(s) that need to be On when in DH2 or DH3 Mode
to enable the Photocell.
Step 3a. Tap 1-8 to select RLYS Buttons:
1 – RLYS Button 1
2 – RLYS Button 2
3 – RLYS Button 3
4 – RLYS Button 4
5 – RLYS Button 5
6 – RLYS Button 6
7 – RLYS Button 7
8 – RLYS Button 8
0 – Factory Default (No RLYS Buttons Assigned)
Step 4. Tap SENS (D) to Capture or Adjust the Low and High Sunlight Settings.
