background image

!

  DANGER

If you smell gas:

• Shut off gas to the appliance.

• Extinguish any open flame.

• Open lid.

• If odor continues, keep away from the appliance and immediately call your fire department.

!

  WARNING

•  Do not store or use gasoline or other flammable 

liquids or vapors in the vicinity of this or any other 

appliance.

•  Any LP cylinder not connected for use shall not be 

stored in the vicinity of this or any other appliance.

This instruction manual contains important information necessary for the proper assembly and safe use of the appliance. Read and follow all warnings and instructions 

before assembling and using the appliance. Keep this manual for future reference. 
Always wait for grill to be completely cooled before opening built-in ash drawer. 
When charcoal cooking above 500º F/260º C, with both top and bottom vents closed, rapidly opening the lid creates a sudden rush of oxygen into the grill, which can 

cause a flare-up of flames. When in this cooking mode, we recommend that, prior to opening the lid, you open both top and bottom vents to allow oxygen to stabilize 

inside the grill before opening, minimizing the possibility of flare-ups.

GENERAL INSTRUCTIONS

1)  The installation conforms with the National Fuel Gas Code, ANSI Z223.1/NFPA 

54, Natural Gas and Propane Installation Code, CSA B149.1; or Propane Storage 

and Handling Code, B149.2.

2)  This outdoor cooking gas appliance shall be used only outdoors and shall not be 

used in a building, garage or any other enclosed area.

3)  This outdoor cooking gas appliance is not intended to be installed in or on boats 

and not intended to be installed in or on recreational vehicles.

4)  Minimum clearance from sides and back of unit to combustible construction, 

32” from sides and 32” from back. The outdoor cooking gas appliance shall not 

be used under overhead combustible surfaces.

5)  Please inspect the hose before each use of the outdoor cooking gas appliance. 

If it is evident there is excessive abrasion or wear, or the hose is cut, it must be 

replaced prior to the outdoor cooking gas appliance being put into operation. 

The replacement hose assembly shall be that specified by the manufacturer.

6)  Lighting Instructions

  (a) Read the instructions before lighting.
  (b) Open lid during lighting.
  (c) Confirm that the control knob on the gas insert is on the “OFF” position.
  (d) Open the gas tank valve knob.
  (e) Press and hold in the Red ignitor button. Device will emit a clicking sound.
 (f)  While holding in the Red ignitor button, Push in the control knob and turn to 

“Low” position; a “click” will be heard, if operated correctly. Observe fire is lit.

  (g) If ignition does not occur within 5 seconds, turn the burner control(s) off, wait 

5 minutes, and repeat the lighting procedure.

7) Note

  (a) Keep outdoor cooking gas appliance area clear and free from combustible 

materials, gasoline and other flammable vapors and liquids.

  (b) Do not obstruct the flow of combustion and ventilation air.
  (c) Keep the ventilation opening(s) of the cylinder enclosure free and clear from 

debris.

  (d) Visually check burner flames including pilot burner flame. 

 (e) Clean outdoor cooking gas appliance, including special surfaces, with 

recommended cleaning agents, if necessary.

  (f)  Check and clean burner/venturi tubes for insects and insect nests. A clogged 

tube can lead to a fire beneath the grill.

8)  If parts are missing, contact Vision Grills at (877) 917-4273 or contact Vision 

Grills via e-mail at [email protected] or through the website at  www.

visiongrills.com.

9)  The cylinder diameter is 12”, the total height is 18” and volume is 20 lbs.
10) The LP gas supply cylinder(s) to be used must be constructed and marked:

 (a) In accordance with the Specifications for LP-Gas Cylinders of the U.S. 

Department of Transportation (D.O.T.) or the National Standard of Canada, 

CAN/CSA-B339, Cylinders, Spheres and Tubes for Transportation of 

Dangerous Goods; and Commission, as applicable.

 (b)  Provided with a listed overfilling prevention device.
 (c) Provided with a cylinder connection device compatible with the connection 

for outdoor cooking appliance.

11) If the outdoor cooking gas appliance is not in use, the gas must be turned off 

at the supply cylinder. Storage of an outdoor cooking gas appliance indoors is 

permissible only if the cylinder is disconnected and removed from the outdoor 

cooking gas appliance.

 

Cylinders must be stored outdoors out of the reach of children and must not be 

stored in a building, garage or any other enclosed area.

12) The pressure regulator and hose assembly supplied with the outdoor cooking 

gas appliance must be used. If pressure regulator and hose assembly are 

missing or need to be replaced, contact Vision Grills at (877)917-4273 or 

contact Vision Grills via e-mail at [email protected] or through the website 

at  www.visiongrills.com.

13) The cylinder used must include a collar to protect the cylinder valve.
14) (a)  Do not store a spare LP-Gas cylinder under or near this appliance; 

 (b)  Never fill the cylinder beyond 80 percent full; and

 (c) If the information in “14-(a)” and “14-(b)” is not followed exactly, a fire 

causing death or serious injury may occur.

15) Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only 

install the type of dust cap on the cylinder valve outlet that is provided with the 

cylinder valve. Other types of caps or plugs may result in leakage of propane.

16) Instructions, including illustrations, on the proper cylinder orientation to provide 

vapor withdrawal.

Subject to the following terms and conditions, Phase 2, LLC, d/b/a Vision Grills 

(“Vision Grills”) warrants to the original purchaser that the grill insert manufactured 

or supplied by Vision Grills will be free from defects in material and workmanship 

under normal use for the following periods from the original date of purchase: 

Five years for burner and all other metal parts; 90 days for lava stone & bracket, 

quick disconnect, hose and regulator. This Warranty is contingent upon purchaser 

registering the product at www.visiongrills.com/register or within 30 days from 

the date of purchase along with a copy of the original dated sales receipt which 

can be attached in an electronic format (i.e. scan, photograph, etc.) to your 

registration at www.visiongrills.com/register. Failure to do so will invalidate the 

warranty. Any damages or defects present at the time of purchase must be 

noted on the original dated sales receipt. This Warranty is not transferable to 

subsequent owners. If you cannot register online, it will be necessary to contact 

Vision Grills customer service at (877) 917-4273 or email [email protected].
If any product covered by this Warranty is defective due to a covered warranty 

condition, such product will, at the option of Vision Grills, be repaired to its original 

condition or replaced with a comparable new product or part. The repair and/or 

replacement of parts shall constitute the extent of the liability and obligations of 

Vision Grills under this Warranty. Purchaser is required to provide photographic 

evidence to assess the damage when submitting claim. 
This Warranty does not cover damages caused by improper assembly, improper 

care, failure to follow directions of use, misuse, abuse, negligence, extreme 

environmental conditions, normal wear and tear, accidents, acts of nature, or 

unauthorized  repair,  alteration  or  modification,  as  determined  by  Vision  Grills. 

Vision Grills is not liable for any default or delay in its performance under this 

Warranty that is caused by any circumstances beyond its control. While Vision 

Grills uses rust-resistant materials, the Warranty as to metal parts does not cover 

rust or oxidation unless the structural integrity of the grill insert is compromised 

as determined by Vision Grills.
This Warranty does not cover purchases with unauthorized resellers and/or third 

parties. Warranty coverage is limited to products purchased at an authorized 

reseller only.
Commercial use and related applications are not covered under this Warranty. 

Warranty coverage is based on normal residential use and maintenance.

Vision Grills shall not be liable for any delay or default under this Warranty caused 

by any event or contingency beyond Vision Grills’s control. This includes acts 

of  nature, fire, government  restrictions or restraints, strikes,  reduced supply of 

materials or transportation delays.

THIS WARRANTY IS THE EXCLUSIVE WARRANTY OF VISION GRILLS. VISION 

GRILLS EXPRESSLY DISCLAIMS ANY AND ALL OTHER WARRANTIES, EXPRESS 

OR IMPLIED, INCLUDING WARRANTIES OF FITNESS, MERCHANTABILITY, OR 

FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER, 

AND VISION GRILLS IS NOT LIABLE FOR, ANY DAMAGES RELATING TO LOSS 

OF TIME, LOSS OF USE OF EQUIPMENT, INCONVENIENCE, OR ANY INCIDENTAL, 

SPECIAL AND/OR CONSEQUENTIAL DAMAGES. PURCHASER’S EXCLUSIVE 

REMEDY FOR BREACH OF THIS WARRANTY SHALL BE LIMITED AS SPECIFIED 

HEREIN TO REPLACEMENT OR REPAIR OF THE AFFECTED PRODUCT. 

Some states do not allow limitations on how long an implied warranty lasts or 

the exclusion or limitation of incidental or consequential damages, so the above 

limitations and exclusions may not apply to you. This Warranty gives you specific 

legal rights, and you may also have other rights which vary from state to state. 

Vision  Grills  does  not  authorize  any  person  or  entity  to  assume  any  obligation 

or liability on its behalf in connection with the sale and purchase of any of its 

products. The purchase of any Vision Grills product from anyone other than Vision 

Grills or an authorized dealer will void the Warranty associated with the product. 

If you have a question regarding the identity of an authorized dealer, you should 

contact Vision Grills before you purchase the product.
To  submit  a  warranty  claim,  the  original  purchaser  or  authorized  agent  of  the 

original  purchaser  must  contact  Vision  Grills  at  (877)  917-4273  or  contact 

Vision  Grills  via  e-mail  at  [email protected]  or  through  the  website  at 

www.visiongrills.com.

WARRANTY

www.visiongrills.com       [email protected]

1-877-917-4273

Vision Grills  1531 Fairview Avenue, Suite B, St. Louis, MO 63132

Summary of Contents for Classic B-Series

Page 1: ...cooking use only Do not operate grill indoors or in an enclosed space Use grill only in well ventilated area around the grill free from combustible materials Allow for at least 3 feet 1 meter of clearance around grill house other outdoor products hanging tree limbs shrubs etc WARNING Keep children and pets away from the grill at all times Do not allow children to operate grill Never leave grill un...

Page 2: ... Press Red Ignition Button and hold in to test battery This will create spark on burner that will start your grill See STARTING SECTION for starting operation Step 4 Install Battery STEP 4 SET UP MAINTENANCE TROUBLESHOOTING 1 After grill has cooled use a soft cloth to clean exterior of grill 2 Clean the cooking grates before and after cooking Note Remove surface dust and grease 3 Infrared Heat Exc...

Page 3: ...e Gas Insert into grill opening in the base of the grill until it stops and locks into place Step 4 Position Heat Exchanger Install the stainless steel infrared Heat Exchanger on top of the Gas Insert Allow the 2 bottom stems of Heat Exchanger to drop into the slots on top of the Gas Insert Step 5 Place Heat Diffuser Lava Stone Spread bracket so it makes an X shape and lower onto fire bowl allowin...

Page 4: ...ver fill the cylinder beyond 80 percent full and c If the information in 14 a and 14 b is not followed exactly a fire causing death or serious injury may occur 15 Place dust cap on cylinder valve outlet whenever the cylinder is not in use Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve Other types of caps or plugs may result in leakage of pro...

Reviews: