DL30x30-G525/UDC/-a
Commissioning
6.3 Connecting
NOTICE
Installation and connection operations may only be performed in the off and
de-energised state.
NOTICE
Cable damage
•
Comply with the specified minimum bending radius.
•
Cables must generally be mounted with a strain relief clamp.
•
Use cables corresponding to the specification (see data sheet).
6.3.1 Connecting to vicolux smart light lighting controller
NOTICE
Damage caused by incorrect connecting and disconnecting
•
The vicolux smart light lighting controller is not hot-plug capable.
•
Connect or disconnect lights during operation may destroy the lights.
•
Connect or disconnect lights only if the lighting controller is in the off and
deenergized state.
The vicolux smart light lightning controllers and adapter cables available as
accessories.
see "vicolux smart light Beleuchtungscontroller", page 12
see "Connection cable lighting (M8, 4-pin) to DLC", page 13
see "Connection cable DLC - operating voltage supply", page 13
Use the M8 adapter cable to connect the device to the vicolux smart light
lighting controller. Observe the instructions for the respective lighting controller.
© Vision & Control GmbH 2019
999.995.536.10-en-1.2
25
