BW-108P AW
9-
ENTER
button and the display will show the number of working hours of the unit. To
go back to the functions press the
MENU
button.
Software version
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the version of software of the unit. To go
back to the functions press the
MENU
button.
4. How To Control The Unit
You can operate the unit in two ways:
1. By master/slave built-in preprogram function
2. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX
address setting will be effected at once. Every time you turn the unit on, it will show
on the display, after that the unit will be ready to receive DMX signal or run
the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other
units to give an automatic show. This function is good when you want an instant show.
You have to adjust the fade time and wait time for the first unit. Its DMX input jack will
have nothing plugged into. The other units will be slave mode automatic.
4.2 Universal DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from
1 to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the
DMX512 address. Once the address has been selected, press and keep
ENTER
button up to when the display stops blinking or storing automatically 8 seconds later.
To go back to the functions without any change press the
MENU
button again.
Please refer to the following diagram to address your DMX512 channel for the first 4
units
：
BW-108P AW
6-
DMX 512 Address Setting
Press the MENU button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the
DMX 512 address. Once the address has been selected, press
ENTER
button to
setup or automatically return to the main functions without any change after 8
seconds. Back to the previous functions without any change press
MENU
button.
Channel Mode
Press the MENU button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to select the
(2 channels) or
(2 Channels) mode. Once the mode has been
selected, press the
ENTER
button to setup or automatically return to the main
functions without any change after 8 seconds. To go back to the previous functions
without any change press the
MENU
button.
