Viscount Cantorum Dou, User Manual

Page: 60 / 166

EN - 4
User Manual
1. [MAN. I] stops: registers for the Bass section are collected here. It is possible to play these registers
through a MIDI pedalboard connected to the [MIDI IN] connector on the rear panel (see point 19) or
with the first manual by activating the Automatic Pedal function (see point 13). In the case of a MIDI
pedal, this must transmit the notes on the reception channel set for the Pedal section (see section 5.4).
2. [MAN. I] stops: here are collected the stops for the Manual I section.
3. [MAN. II] stops: here are collected the stops for the Manual II section.
4. Control and programming section.
The buttons and the display in this sections allow the user to program and set up the instrument and
the sequencer.
-
[VOLUMES]: access the video page for all the volumes of the instruments.
-
[SEQUENC.]: access the video pages for the use of the internal sequencer of the instrument.
-
[FIELD

] and [FIELD

]: buttons used to move the cursor, identified by the field in reverse.
[FIELD

] moves it in the field above or the previous field, [FIELD

] in the field below or the
next field.
-
[VALUE +] and [VALUE -]: buttons which regulate the values of the parameters, whether they
are numerical or alphanumerical. [VALUE +] increases, [VALUE -] decreases.
-
[EXIT] and [ENTER]: access and quit the display screens and menus, or confirm or cancel
prompts made by the system. [ENTER] accesses menus/screens and confirms, [EXIT] quits
menus/screens and cancels.
5. [VOLUME] slider: controls the overall volume of the organ.
6. [REVERB] slider: controls the amount of reverberation effect.
2. GENERAL DESCRIPTION OF THE INSTRUMENT
1 2 3 4
5 6