STRUT
(by others)
1/4-20 THREADED ROD
(by others)
SUPPORT
(by others)
* Note: This fixture is supported from the structure above the sheetrock ceiling.
SHEETROCK INSTALLATION:
Provide a framed opening for centering the fixture. The LED housing opening should measure
1.
between 44-1/2" and 48" square. This will help support the fixture when it is fully installed.
Remove lens and trim frame. Re-attach the trim frame screws to the LED housing for use
2.
later. The lens and trim frame are not re-installed until all sheetrock work is completed.
Remove driver/wiring cover.
3.
Secure the fixture to the structure above using threaded rod and nuts into the (4) .281 holes
4.
provided (see page 2). Make sure to locate the fixture so the bottom of the square housing is
1-3/8" (+0.00"/-0.125") above the bottom of the finished surface.
NOTE:
Adjustment to the
fixture height is done by raising or lowering the fixture using the threaded rods. Do not fully
tighten the fixture yet.
Make all the electrical connections required and following local codes that apply.
5.
Re-attach driver/wiring cover.
6.
Complete sheetrock installation.
NOTE:
Protect LEDs during sheetrock installation and
7.
finishing.
Once sheetrock is completed, cut circular opening for trim frame.
NOTE:
Opening diameter to
8.
be 43.75" to 44.25".
Remove trim frame screws and re-attach the trim frame to the housing.
NOTE:
If the trim
9.
frame is not flush with sheet rock, raise or lower fixture at the threaded rod.
Re-attach the lens assembly.
10.
Drawing:
762262XX
Rev:
A
Sheet:
3 of 6
Eng:
CG2
Date Drawn:
1/11/17
INSTALLATION INSTRUCTIONS
Model:
CM1970-W, CM1972-W, CM1972-T
Fixture Family:
SYMMETRY
1717 West Civic Drive Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© Visa Lighting 2016
!
When using electrical equipment, basic safety precautions should always be followed, including the following:
Read all instructions carefully before installing and save for future use.
•
Make sure all connections are in accordance with the National Electrical Code and local regulations.
•
To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
•
Service should be performed by qualified personnel.
•
These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.
•
Document Description: Installation Instructions for
Symmetry Series Luminaires