Option 2 - The Yellow Jack
Using a special adaptor cable, up to two wireless headsets can be connected to the “Yellow” jack on
the rear of the Vitalinq 94A-07 console. Two-way communication is then possible between the
wireless headset(s) plugged into the “Yellow” jack and any headset (corded or wireless) plugged into
one of the two “Headset” jacks located on the front of the Vitalinq console. Note that headsets
plugged into the “Yellow” jack do not provide two-way communication with the procedure room.
1) Locate the “Sennheiser Yellow Jack Cable” (P/N: SYJC0312). This cable is made by Vis-A-Vis and will be
included with your wireless headset when purchased from Vis-A-Vis.
It is not a Sennheiser cable.
This
cable has a ethernet (RJ45) connector on one end with two cables leading from it to a pair of ethernet
connectors.
2) Plug the ethernet connector with the two cables attached to it into the jack on the rear of the Vitalinq
console labeled “Yellow”.
3) Plug one of the two ethernet connectors into the jack labeled “Phone” on the rear of one of the Sennheiser
wireless headset base stations (color coded green). Repeat for the other Sennheiser base station. You
should now have both base stations plugged into the “Yellow” jack on the Vitalinq console via the
“Sennheiser Yellow Jack Cable”.
4) Follow steps 4 through 8 under “Option 1” of these instructions to complete the setup.
When using a corded headset on the front of the console
Page 4
