PART A: Basic machine
Shredder
L 60; L60+
©
VIRTUS EQUIPMENT 2018 All rights reserved
Page 10
4.2
Use in accordance with the regulations
The operational safety of the delivered machine is only
guaranteed for use in accordance with the regulations!
This regulation use is only achieved if the following points are
observed and fulfilled.
Manufacturing process and grinding material
The shredder is suitable exclusively for the grinding of material,
which corresponds to the agreed customer-specific specifications
in all points (see C
ontract of sale
).
Any other work or design will differ from the specified
requirements. VIRTUS EQUIPMENT will not be held responsible.
The specified requirements also include all information found in
the owner’s manual such as maintenance and service.
Any change in the specifications or requirements must be brought
to the attention of VIRTUS .
Suction unit
If emissions occur during grinding of material, which exceed the
permissible legal values for contaminants in the air, the shredder
may only then be operated when the customer has installed a
suitable air suction device on site.
Safety device for the in feed hopper
In the case that your design of the shredder does not contain any
additional in feed device (e.g. nip roll feed device), the in feed
hopper must be safeguarded in a suitable way against persons
reaching in or falling in.
If, without our knowledge, the machine is installed "underground"
on site, it is deemed to be installation contrary to the intended
purpose. The attached manufacturer's declaration alone, stating
that the machine may not be operated without additional
measures
Connection of the Emergency Stop button
The machine may only be operated with the installed Emergency
Stop buttons. In case no Emergency Stop buttons have been
installed, an Emergency Stop button must be mounted on the
control cabinet, the second on the material in feed.
