26
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Defective burner (gas outlet holes clogged).
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Defective gas valve.
ELECTRIC FRY-TOP
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- Temperature thermostat defective.
- Heating elements defective.
- Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Temperature thermostat defective.
12.
REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY,
IF
PRESENT,
BEFORE
CARRYING OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS FRY-TOP WITH TAP
REPLACING THE GAS TAP.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER, THE PILOT BURNER, THE
THERMOCOUPLE, THE PIEZOELECTRIC IGNITION
AND THE IGNITER
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
GAS FRY-TOP WITH VALVE
REPLACING THE GAS VALVE AND SAFETY
THERMOSTAT.
- Remove the control panel.
- Remove the bulb from its seat on the bottom of
the hotplate.
- Remove and replace the component.
- Insert the bulb properly in its seat on the bottom of
the hotplate.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER, THE PILOT BURNER, THE
THERMOCOUPLE, THE PIEZOELECTRIC IGNITION
AND THE IGNITER
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC FRY-TOP
REPLACING THE HEATING AND LIGHT GLOWS.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the bottom of
the hotplate.
- Remove and replace the component.
- Insert the bulb properly in its seat on the bottom of
the hotplate.