Viron P320 eVo, Installation And Operating Instructions Manual

Page: 18 / 128

Installation and General Maintenance Manual – Viron eVo Pool Pump
18
If using a compatible AstralPool Gas Heater you can automatically increase the speed of your Viron eVo pump
to ensure the water pressure switch is activated and the heater obtains enough water flow to operate
correctly.
A RJ12 (6 wire flat cable) specifically wired and obtained from AstralPool will connect your pump and heater.
Refer to Heater Instruction Manual for data cable connection details.
Viron Pump when connected to Viron Heater or other compatible AstralPool Heater via RJ 12 cable
Viron Heater Status Viron Pump response
When heater is “off” Runs at default speed set.
When “on” but not lit
Runs at a minimum of medium speed. The user can use the buttons to select
medium or high only (low speed button has no effect). The “start-up period” is
cancelled.
When flame first lights Runs at high speed. The user cannot change the pump's speed.
When flame is lost Runs at default speed set or medium speed if heater power on.
Viron Pump when connected to Viron Heater or other compatible AstraPool Heater via Viron Connect
Viron Heater Status Viron Pump response
When heater is “off”
Runs at the user's manual speed or the chosen default speed when operating
due to timers.
When “on” but not lit
Changes to the higher of the speed which is configured by the user in the
Installation Setup (the “Heater On” speed); or, the speed of the current timer.
The user cannot change to low speed.
When flame first lights Runs at high speed. The user cannot change the pump's speed.
When flame is lost
Runs at the user's manual speed or the chosen default speed when operating
due to timers.
24 Volt Data (RJ12
Cable)