Owner’s manual
10
EN
OPERATION:
1. Insert the projector on the tripod (for indoor use) or to the
ground stake (for outdoor use).
2. Connect the 2-pin plug of the power cord to the adaptor inlet
ensuring proper polarity (note the indentation on the plug) and
to the projector. To avoid water getting in, make sure to turn the
plug cap clockwise until secure.
3. Connect the adapter to an approved electrical outlet.
4. Press the power switch to change light mode.
Slides replacement:
The set includes four replaceable slides. To replace the slide, twist
off two fastenings on the top of the device (2) and remove the
slide that is currently in the device (1). Place the new one (pay
attention to the cutout in the middle of the slide), and then screw
the fastenings. Slides should not be inserted from the backside.